Kramer Electronics f-110 User Manual download pdf (Page 7)

Connecting the F-110

5 Connecting the F-110

The Kramer F-110 together with the Kramer PT-120 or TP-120 XGA line

receivers constitute a VGA/XGA-to-twisted pair transmitter and receiver.

To connect the F-110, do the following:

1. Unscrew the two screws that fasten each of the two adjacent blank

plates to the connecting surface and remove them.

2. Place and align the F-110 dual-slot wall-plate insert over the opening.

3. Connect the cables to the rear side of the insert, that is, attach the:

 Terminal block line output of the F-110 to the pre-installed UTP

wiring that connects to the TP receiver (with a range of more than

300ft (>100m)), see section 5.1

 12V DC power supply to either one of the power terminal blocks

(connect the wire labeled “+” to the +12V pin, and the wire labeled

“–” to the GND pin) taking care that the polarity is correct. You can

use the second power terminal block to power an additional unit (for

example, an adjacent insert on the mounting surface)

4. Insert the four screws to fix the insert in place, and tighten them.

5. Connect the UXGA source to the PC IN connector (for example, a

computer graphics source).

1 2 3 4 5 6 7 8 9 10 11 12 13 14

No comments

Kramer Electronics f-110 User Manual Page 7