Figure 2: VS-66HN 6x6 HDMI Matrix Switcher Rear Panel
OUTPUT HDMI Connectors (1 to 6)
Connect to up to 6 HDMI acceptors
INPUT HDMI Connectors (1 to 6)
Connect to up to 6 HDMI sources
RS-232 9-pin D-sub Connector
Connect to a PC/serial controller
Connect to a PC via a LAN
Press to reset to the factory default IP parameters:
IP number 192.168.1.39
Mask – 255.255.255.0
Gateway – 192.168.1.1
Depress the button while powering on the device. The device powers up with the factory
default IP parameters
Connect to an external IR receiver for controlling the device via and IR remote controller
(see Section 3.2)
Covered by a cap. The 3.5mm jack at the end of the internal IR connection cable fits into this
opening
Connect to the mains power
Fuse for protecting the device
Switch for turning the device on or off
Comments to this Manuals