Sensor for the remote control IR transmitter
Lights yellow when receiving signals from the IR
remote control transmitter
REMOTE IR 3.5mm Mini Jack
Connect to a remote IR sensor
Press (when one of the input LEDs is flashing to
indicate a selected input) to read the selected EDID
(see Section 5.1)
Press repeatedly to cycle through the inputs to select
an input from which to read the EDID. The relevant
LED flashes (see Section 5.1)
The relevant LED lights green when an acceptor is
connected to the output
Also lights or flashes during EDID setup (see
Section 5.2)
Lights green when the unit receives power
Press to select an input. The relevant IN 1 HDMI/IN
2 CAT5 LED lights
Lights green when HDMI input 1 is selected
Lights green when the TP CAT 5 input 2 is selected
RS-232 9-pin D-sub (F)
Connector
Connect to a PC or remote controller
Connect to the +12V DC power adapter, center pin
positive
IN1 (HDMI)
Input HDMI
Connector
Connect to an HDMI source
IN2 (CAT5)
Input RJ-45
Connector
Connect to a TP source (for example, PT-571 HDMI
Line Transmitter, VM-114H2C or VM-114H4C)
Connect to the HDMI acceptors
TP RJ-45
Output
Connectors
Connect to the TP acceptors (for example, PT-572+
HDMI Line Receiver, VM-114H or VM-114H4C)
Comments to this Manuals